| Abstract | In classical mechanical testing, determining the stress and strain states of complex shape specimens turns out to be very challenging, especially in the most deformed regions. In the latter case, when not enough material is present, non-destructive testing is needed for determining the corresponding mechanical state. In this study, a novel approach, based on the local quasi-non-destructive instrumented indentation technique (IIT) coupled with the inverse analysis technique (IAT), is used to determine the stress and strain levels of pre-strained DC01 specimens using monotonic and non-monotonic loading paths. Monotonic and cyclic shear tests as well as Marciniak tests, in both plane and equi-biaxial strain states, are used to apply different pre-strain levels. For monotonic loading paths, i.e. monotonic shearing and Marcianiak tests, the applied methodology showed very satisfying results in determining the stress and strain states of the pre-strained specimens, especially for pre-strain values close to the representative indentation strain values. A maximum stress error of less than 15% was obtained in the case of the highest applied pre-strain value (29.04%). The purely isotropic Voce hardening law was adopted for determining the hardening behavior of the studied specimens in both cases: as-received and pre-strained. In the case of cyclic shear, a mixed isotropic-kinematic hardening law is to be used to determine the stress and strain states of the pre-strained specimens. Adopting a mixed isotropic-kinematic Chaboche hardening law led to satisfying results where the estimation errors of the applied pre-strain value and corresponding yield stress didn't exceed 6% and 1.3%, respectively. The obtained results show that the proposed indentation-based method can be very useful in estimating the work-hardening level and corresponding plastic deformation of pre-strained parts under various loading paths. |
|---|
