| DOI | Trouver le DOI : https://doi.org/10.1080/10910340903237889 |
|---|
| Auteur | Rechercher : Shi, Z.1; Rechercher : Attia, H.1; Rechercher : Srinivasaraghavan, M. |
|---|
| Affiliation | - Conseil national de recherches du Canada. Institut de recherche aérospatiale du CNRC
|
|---|
| Format | Texte, Article |
|---|
| Sujet | contact zone; Cubic Boron Nitride (CBN); force distribution; grinding |
|---|
| Résumé | This paper is concerned with the experimental investigations for the prediction of the grinding force distribution in the grinding wheel and workpiece contact zone. A new approach was developed to predict the force distribution using the horizontal and vertical forces measured while grinding a workpiece with a shorter length along the grinding pass. Straight surface grinding experiments were conducted using straight oil as grinding fluid on a nickel-based alloy (IN718) with a 60-grit 150 mm diameter electroplated CBN wheel to implement this approach and to investigate the effects of wheel speeds and workspeeds on the distributions. Grinding power and forces were measured. It was found that the distribution along contact arc increases with a decreasing rate from bottom to top. Wheel speeds have a significant effect on the normal force distribution at the higher removal rate. The grinding power was estimated to verify the predicted force distribution and it was found to be in a good agreement with the measured power. |
|---|
| Date de publication | 2009-08-31 |
|---|
| Maison d’édition | Taylor & Francis |
|---|
| Dans | |
|---|
| Langue | anglais |
|---|
| Publications évaluées par des pairs | Oui |
|---|
| Numéro NPARC | 23004836 |
|---|
| Exporter la notice | Exporter en format RIS |
|---|
| Signaler une correction | Signaler une correction (s'ouvre dans un nouvel onglet) |
|---|
| Identificateur de l’enregistrement | 968157c8-59d3-4fec-82d0-6706a072cc84 |
|---|
| Enregistrement créé | 2019-01-03 |
|---|
| Enregistrement modifié | 2020-04-16 |
|---|
