| Téléchargement | - Voir la version finale : Measurement accuracy in silicon photonic ring resonator thermometers: identifying and mitigating intrinsic impairments (PDF, 3.5 Mio)
|
|---|
| DOI | Trouver le DOI : https://doi.org/10.1364/OE.499055 |
|---|
| Auteur | Rechercher : Janz, S.1; Rechercher : Dedyulin, S.2; Rechercher : Xu, D. X.1Identifiant ORCID : https://orcid.org/0000-0002-0490-5224; Rechercher : Vachon, M.1; Rechercher : Wang, S.1; Rechercher : Cheriton, R.1Identifiant ORCID : https://orcid.org/0000-0003-0522-0187; Rechercher : Weber, J.1 |
|---|
| Affiliation | - Conseil national de recherches du Canada. Quantique et nanotechnologies
- Conseil national de recherches du Canada. Centre de recherche en métrologie
|
|---|
| Format | Texte, Article |
|---|
| Résumé | Silicon photonic ring resonator thermometers have been shown to provide temperature measurements with a 10 mK accuracy. In this work we identify and quantify the intrinsic on-chip impairments that may limit further improvement in temperature measurement accuracy. The impairments arise from optically induced changes in the waveguide effective index, and from back-reflections and scattering at defects and interfaces inside the ring cavity and along the path between light source and detector. These impairments are characterized for 220 × 500 nm Si waveguide rings by experimental measurement in a calibrated temperature bath and by phenomenological models of ring response. At different optical power levels both positive and negative light induced resonance shifts are observed. For a ring with L = 100 µm cavity length, the self-heating induced resonance red shift can alter the temperature reading by 200 mK at 1 mW incident power, while a small blue shift is observed below 100 µW. The effect of self-heating is shown to be effectively suppressed by choosing longer ring cavities. Scattering and back-reflections often produce split and distorted resonance line shapes. Although these distortions can vary with resonance order, they are almost completely invariant with temperature for a given resonance and do not lead to measurement errors in themselves. The effect of line shape distortions can largely be mitigated by tracking only selected resonance orders with negligible shape distortion, and by measuring the resonance minimum wavelength directly, rather than attempting to fit the entire resonance line shape. The results demonstrate the temperature error due to these impairments can be limited to below the 3 mK level through appropriate design choices and measurement procedures. |
|---|
| Date de publication | 2023-12-19 |
|---|
| Maison d’édition | Optica Publishing Group |
|---|
| Licence | |
|---|
| Dans | |
|---|
| Langue | anglais |
|---|
| Publications évaluées par des pairs | Oui |
|---|
| Exporter la notice | Exporter en format RIS |
|---|
| Signaler une correction | Signaler une correction (s'ouvre dans un nouvel onglet) |
|---|
| Identificateur de l’enregistrement | 9f06f644-2b53-4422-9fec-5f68634811ea |
|---|
| Enregistrement créé | 2024-06-10 |
|---|
| Enregistrement modifié | 2024-06-10 |
|---|
