| Résumé | When using biodosimetry techniques to assess absorbed dose from an ionising radiation exposure, a calibration curve is required. At Health Canada (HC), these curves are generated for a variety of radiation qualities and assays to translate biological damage into absorbed dose. They are produced by irradiating biological samples in custom-designed water-equivalent phantoms inside a cabinet X-ray machine. In the HC lab, two different phantoms can be used for irradiation that differs in material composition and internal geometry. To ensure consistency, the impact of using the phantoms interchangeably was investigated. This was done through lab measurements and the development of a Monte Carlo (MC) model. Differences up to 6.7% were found between the two experimental setups, indicating the need for careful consideration if using these setups interchangeably in the laboratory. Once validated, the MC model can be used to investigate different aspects of the experimental setup without the need for laboratory measurements. |
|---|
