| Résumé | Most active optical range sensors record, simultaneously with the range image, the amount of light reflected at each measured surface location: this information forms what is called a range intensity image, also known as a reflectance image. This paper proposes a method that uses this type of image for the correction of the color information of a textured 3D model. This color information is usually obtained from color images acquired using a digital camera. The lighting condition for the color images are usually not controlled, thus this color information may not be accurate. On the other hand, the illumination condition for the range intensity image is known since it is obtained from a controlled lighting and observation configuration, as required for the purpose of active optical range measurement. The paper describes a method for combining the two sources of information, towards the goal of compensating for a reference range intensity image is first obtained by considering factors such as sensor properties, or distance and relative surface orientation of the measured surface. The color image of the corresponding surface portion is then corrected using this reference range intensity image. A B-spline interpolation technique is applied to reduce the noise of range intensity images. Finally, a method for the estimation of the illumination color is applied to compensate for the light source color. Experiments show the effectiveness of the correction method using range intensity images. |
|---|
