| DOI | Trouver le DOI : https://doi.org/10.1109/IECON48115.2021.9589877 |
|---|
| Auteur | Rechercher : Boby, Mathews; Rechercher : Singh, Sumeet; Rechercher : Lamarre, Jean-Michel1; Rechercher : Ibrahim, Maged1; Rechercher : Bernier, Fabrice1; Rechercher : Pillay, Pragasen |
|---|
| Affiliation | - Conseil national de recherches du Canada. Automobile et les transports de surface
|
|---|
| Format | Texte, Article |
|---|
| Conférence | IECON 2021: 47th Annual Conference of the IEEE Industrial Electronics Society, October 13-16, 2021, Toronto, ON, Canada |
|---|
| Sujet | impulse magnetizer; permanent magnet rotor; cold spray additive manufacturing; in-situ magnetization; post-assembly magnetization; magnetization; rotors; stators; three-dimensional printing; SPICE; software |
|---|
| Résumé | The design, simulation and testing of an impulse magnetizer and the in-situ post-assembly magnetization of a permanent magnet (PM) rotor manufactured by a cold spray additive manufacturing (AM) using the prototyped magnetizer is presented in this paper. A software based finite element simulation is done to obtain the level of magnetization current required. An impulse magnetizer is built for this specification. A 4-pole rotor with cold-sprayed rectangular magnets is magnetized in this work after assembling it in the stator. Various stator terminal connection configurations are analyzed. The machine is magnetized and the back-EMF waveform and the rotor magnetization profile is obtained. |
|---|
| Date de publication | 2021-10-13 |
|---|
| Maison d’édition | IEEE |
|---|
| Dans | |
|---|
| Langue | anglais |
|---|
| Publications évaluées par des pairs | Oui |
|---|
| Exporter la notice | Exporter en format RIS |
|---|
| Signaler une correction | Signaler une correction (s'ouvre dans un nouvel onglet) |
|---|
| Identificateur de l’enregistrement | a5789b41-ef85-49d4-98d9-0763194c44f3 |
|---|
| Enregistrement créé | 2023-01-20 |
|---|
| Enregistrement modifié | 2023-01-20 |
|---|
